Old bubbling or purple film stripped off clean, the glass polished, and redone properly.
Get a free estimateTell us your number and we will call you back.
Tint that has bubbled, peeled or turned purple is old dyed film breaking down. The old film and the glue under it come off, the glass gets cleaned and polished, and new carbon or ceramic film goes on. Back glass is stripped carefully around the defroster lines.
Old tint fails in a predictable order. The color goes first, which is why cheap film turns purple as the dye breaks down in the sun. Then the adhesive gives up and bubbles show up, usually on the back glass where the sun hits hardest. By the time it is peeling at the edges, the film is doing almost nothing for heat and it makes the car look neglected.
Removal is the part that takes patience. Pulling bubbled film off cold usually tears it into strips and leaves the glue behind on the glass. The film is heated so it lets go in larger pieces, then the leftover adhesive is cleaned off before anything new goes on. Any glue left on the glass would show through the new film.
The back glass needs the most care because the defroster lines are printed right on the inside of the glass. Scraping them the wrong way can break a line, and a broken line means that strip of the defroster stops working. Once the glass is clean, the new carbon or ceramic film goes on the same way as a fresh tint job, and you pick a new shade within the legal range for your vehicle.
That is usually cheap dyed film breaking down in the sun. The dye fades to purple and the adhesive lets go, which shows up as bubbles. Carbon and ceramic film do not fade that way.
No. New film cannot go over old film, so the old layer and its glue come off first. That is part of the re-tint job.
You can, but cold film usually tears and leaves the glue on the glass, and the back glass defroster lines are easy to damage. Doing it with heat and the right tools keeps the glass and the defroster intact.
Not when it is done carefully. The defroster lines sit on the inside of the back glass, so the film and glue are worked off without scraping across them.